Operating ITCU: Before printing - ITCU Advanced Operator's Manual May 14, 2022 12:51 Updated v2.0.0 To do before printing Make sure that the Coloreel ITCU is on. Make sure that the Coloreel ITCU is correctly threaded. Ensure that the ambient temperature and humidity are inside the specified levels, both before and during print. Refer to Technical data. Make sure that the Waste Tank is not filled up. The Coloreel ITCU will show a notice on the display when the waste tank needs to be replaced. Refer to Maintenance, if the Waste Tank needs to be replaced. Make sure that the cartridge ink levels are not low and in need of replacement. The Coloreel ITCU will show a notice on the screen when the ink levels are low. Refer to Maintenance, if an Ink Cartridge needs to be replaced. Go to the Network tab and ensure that the Coloreel ITCU has an IP address. Refer to Settings. Examine the washing fluid level and the lubrication level. The maximum amount of washing fluid is 250 ml and the lubrication level must be within the minimum and maximum level of the container. Comments 0 comments Please sign in to leave a comment.