Embroidery machine settings - Barudan - recommended for the Coloreel unit October 08, 2022 11:40 Updated Barudan embroidery machine settings that are affecting stitch counting at the Coloreel unit. This recommendations will improve CCP Stitch counting is important to maintain a good Color Change Precision and to handle Thread breaks and Start at Stich in a good way. With correct settings you should expect an accuracy of 1-2 stitches in almost all cases. Recommendations for Barudan BEXR-series Recommendations for Barudan BEKT-series . Recommended machine settings in Bold reflects changes from Barudan default Barudan BEXR-series ITCU Menu position Setting name Recommended setting Corresponding CCP setting in the ITCU Comments 2 Trim Jumps 3 Jump convert: 3 Setting of how many consecutive jump stitches that will cause thread trimming and move the frame to next stitch 3 Return stitch 1 Tie ins: 4 Set number of Return stitch (machine added tie ins) at start of embroidery 6 Trim Type 1 Tie stich length: 0,4 Pantograph moves 0,4 mm to the left before the needle penetrates and the thread is trimmed 8 Trim Vector 0 Tie offs: 2 Only for machine with MK-6 trimming device 10 Jump Divide 127 - If set to other level than 127, the embroidery machine will add main shaft revolutions that the ITCU do not account for. The recommended setting may cause overspeed for the ITCU! Do not use stitches longer than 12,7 mm 11 Stitch Back 4 Thread break ties: 0 Setting to perform Frame back automatically at thread breakage. 12 Overlap 0 - Set how many times inching is performed when the operation starts again after stopping the machine during embroidery 19 T-Break 5 - Set the sensitivity of detection when the thread breaks. Do not set too sensitive, it may cause false alarms .. Recommended machine settings in Bold reflects changes from Barudan default Barudan BEKT-series ITCU Menu position Setting name Recommended setting CCP setting in the ITCU Comments MC1 -04 T-Break count 5 - Set the sensitivity of detection when the thread breaks. Do not set too sensitive, it may cause false alarms MC1 - 07 Stitch Back 0 Thread break ties: 0 Setting to perform Frame back automatically at thread breakage. MC1 - 12 Trim Jumps 3 Jump convert: 3 Setting of how many consecutive jump stitches that will cause thread trimming and move the frame to next stitch MC1 - 13 Jump Divide 127 - If set to other level than 127, the embroidery machine will add main shaft revolutions that the ITCU do not account for. The recommended setting may cause overspeed for the ITCU! Do not use stitches longer than 12,7 mm MC1 - 16 0 admit 0 Do not let the machine remove 0-length stitches MC1 - 17 Combine Data 0 Do not let the machine change stitch lengths MC2 - 07 Lock stitch 3 Tie ins: 4 Set number of Return stitch (machine added tie ins) at trim MC2 - 09 Trim Type 1 Tie stich length: 0,4 Pantograph moves 0,4 mm to the left before the needle penetrates and the thread is trimmed MC2 - 10 Trim dir 2 Tie offs: 2 Setting for pantograph movements after trims MC2 - 11 Trim Vector 0 Setting for pantograph movements before trims MC2 - 23 Trim mode 0 Type of trimming movements DownlDownload printer friendly .pdf here: TSD.10017.2 Barudan_Coloreel CCP Settings.pdf 200 KB Download Comments 0 comments Please sign in to leave a comment.