Incorrect stitch data

Items to check if the Stitch data reported by the ITCU is incorrect and doesn't comply with the stitch data at the embroidery machine

1. Check the stitch count settings in the CCP data of the Operator panel matches the embroidery machine settings. Refer to the Full Operator Manual
2. Check that the stitch numbers of the color file (.CSE) and the stitch file loaded into the embroidery machine are the same.
   1. • Note! Always use the .DST file used to create the .CSE-file at the embroidery machine. Transferring of stitch data through your Digitising software might give another stitch count and stitch data...
3. Adjust the position of the Stitch Sensor to make sure that it reads the embroidery machine movements.
4. Make sure that the Stitch Sensor Cable is not broken or damaged.