Foaming in the washing module

The washing fluid in the washing module and hoses is foaming

This will mostly occur when the level of washing fluid is too low.

Follow the steps below to add washing fluid to the Washer Module.

• Refer to Maintenance in the Operator's Panel
• If you don't know how much washer fluid is in the unit, empty the washer completely. Both the Trough and the Reservoir. Maximum 300ml including the hoses and filters.
• Fill up the washer reservoir with 180-200 ml.
• Fill the trough with 60-100 ml.   
  1. Remove the fill cover from the Washing Modules reservoir.
  2. Use the Syringe included int the Start Kit to empty/refill the Washing Module
  3.  Replace the Fill cap when finished
  4. Lift the lid on the trough and use the Syringe to empty/refill.
  5. Close the lid on the trough and you are done