Press the Start button (A) when the Coloreel ITCU is warm. The Start button (A) becomes active when the warm up process is complete
A screen is showing with a prompt saying 'Pull thread to the marker, then start the embroidery machine'
Pull the thread so that the colored start marker on the thread passes through the eye of the needle of the embroidery machine. It is necessary to pull approximately 3 m before the start marker is shown on the thread
Fasten the thread with the colored start marker (B) onto the embroidery machine. The end of the colored start marker (B) must reach 70 mm from the needle
Start the embroidery machine. Refer to the manual of the embroidery machine
The printing starts and as the design is colored, the ring is filled with a thicker green line and the stitch counter increases until it reaches the total number of stitches of the design
When the printing is finished, press the green button (C) to finish the print job