Weekly Maintenance April 25, 2022 09:23 Updated Weekly or after 40 hours of operation Examine the Washer Fluid level. Add Washer Fluid if it is necessary. Use a syringe filled to half with washing fluid. Enter the tube approximately 2 cm into the Washer tank (remove the red cover). Pull the syringe outwards. If air is being entered into the syringe, add some washing fluid. Repeat until washing fluid, not air enters the syringe while pulling it. Make sure that the Washer Fluid is flowing to the Washer tank through the Active Carbon Filter. You can see the fluid transport through the clear tubes connecting the filters to the Washing unit Examine the Lubrication level. Add Lubrication if it is necessary. Clean all thread guides and thread contact points in the Coloreel ITCU and the embroidery machine from excess Ink and Lubrication. Use a Q-tip to clean the guides. Clean the Contact Fixation Unit with Scotch Brite and Cleaning Fluid Note! Scrub hard with the Scotch Brite pad to clean the contact fixation heat elements! Examine the Ink levels. Make sure that the expiration date on the Ink Cartridges has not expired. You can access detailed information about the cartridges using Service Tool - Levels Comments 0 comments Article is closed for comments.